铌对中碳Si-Mn系弹簧钢珠光体相变行为的影响

Effect of niobium on pearlite transformation in medium-carbon Si-Mn spring steel

  • 摘要: 采用热模拟实验方法研究了铌对Si-Mn系弹簧钢相变特征的影响,分析了NbC的形变诱导析出行为.结果表明:弹簧钢中添加微量铌,推迟了珠光体转变,马氏体转变的最小冷却速率由5℃·s-1变为3℃·s-1;细化了珠光体,改变了珠光体组织形貌,渗碳体片层变薄、形状变得不规则,出现弯曲、断续;含铌弹簧钢在850℃变形时发生了NbC的形变诱导析出,NbC的析出位置为珠光体中的铁素体片层内、珠光体球团边界和位错处,析出物颗粒直径为10~15nm,形状近似球形.

     

    Abstract: The effect of niobium on the phase transformation law of Si-Mn spring steel was studied by thermal simulation experiment, and the deformation-induced precipitation behavior of NbC was analyzed.The results show that pearlite transformation is delayed;and the minimum cooling rate of martensite transformation is reduced from 5 ℃·s-1 to 3 ℃·s-1.The pearlite lamellar spacing is refined, and the cementite lamellae become thinner, irregular, bending and discrete.Deformation-induced precipitation NbC locates in the ferrite lamellae, pearlite pellet borders and dislocations when the Nb-bearing spring steel was deformed at 850 ℃, and NbC is approximately spherical shape with a diameter of 10 to 15 nm.

     

/

返回文章
返回